HTC Shear Model 250-10A Installation & Operating Instruction Manual

2.1 Seguridade xeral

• Always wear appropriate personal protective equipment (PPE), including safety glasses, gloves, and steel-toed boots.
• Asegúrate de que a área de traballo estea limpa, ben iluminada e libre de obstáculos.
• Never operate the shear under the influence of drugs or alcohol.
• Only trained and authorized personnel should operate or maintain this equipment.

2.2 Seguridade eléctrica

• Asegúrese de que a máquina estea correctamente conectada a terra.
• Desconecte a alimentación antes de realizar calquera mantemento ou axuste.
• Do not operate with damaged power cords or plugs.

2.3 Hydraulic Safety

• Check hydraulic fluid levels regularly.
• Be aware of high-pressure hydraulic lines; leaks can cause serious injury.
• Use only recommended hydraulic fluids.

3.1 Desembalaxe e inspección

Carefully unpack the HTC Shear Model 250-10A. Inspect all components for any shipping damage. Report any damage to the carrier immediately. Verify that all parts listed in the packing list are present.

3.2 Preparación do lugar

The shear requires a level, stable concrete foundation capable of supporting its weight and operational forces. Ensure adequate space around the machine for safe operation and maintenance access. Provide proper ventilation and lighting.

3.3 Conexión eléctrica

Connect the shear to a dedicated electrical circuit as specified in the electrical requirements section (refer to Section 7). Ensure all connections comply with local electrical codes. A qualified electrician should perform this step.

3.4 Hydraulic System Initial Fill

Fill the hydraulic reservoir with the recommended hydraulic fluid (refer to Section 7) to the specified level. Bleed air from the hydraulic system according to the detailed procedure outlined in the service manual.

4.1 Lista de verificación previa á operación

• Verify all safety guards are in place and functional.
• Check hydraulic fluid level.
• Inspeccione as láminas para comprobar se están afiadas e se presentan danos.
• Ensure the work area is clear.
• Confirm emergency stop buttons are accessible and operational.

4.2 Arranque da máquina

1. Xire o interruptor principal á posición "ON".
2. Press the "START" button on the control panel.
3. Allow the hydraulic pump to build pressure (indicated by pressure gauge).

4.3 Shearing Procedure

1. Position the material to be cut firmly against the back gauge and hold-downs.
2. Ensure fingers and clothing are clear of the blade area.
3. Activate the shear cycle using the foot pedal or control buttons.
4. Wait for the blade to complete its cycle and return to the up position before removing the cut material.

4.4 Parar a máquina

• Press the "STOP" button on the control panel.
• Turn the main power switch to the "OFF" position when finished operating or leaving the machine unattended.
• In an emergency, press the nearest emergency stop button.

5.1 Mantemento diario

• Clean the machine, removing all metal scraps and debris.
• Check hydraulic fluid level.
• Inspect blades for wear or damage.
• Lubricate moving parts as specified in the lubrication chart.

5.2 Mantemento semanal

• Check and adjust blade gap if necessary.
• Inspect hydraulic hoses and fittings for leaks.
• Limpar ou substituír os filtros de aire.

5.3 Mantemento periódico

• Change hydraulic fluid and filter (every 2000 operating hours or annually).
• Inspect electrical connections for tightness.
• Calibrate back gauge and other measuring systems.