FLOWPAC FX701-Orange 12V DC Submersible Utility Sump Pump Instruction Manual

Introdución

This manual provides essential instructions for the safe and efficient operation and maintenance of your FLOWPAC FX701-Orange 12V DC Submersible Utility Sump Pump. Please read this manual thoroughly before installation and use, and retain it for future reference.

Información importante de seguridade

• Always disconnect the power source (battery) before performing any maintenance or cleaning on the pump.
• Do not operate the pump with no water. Dry running can cause severe damage to the motor and internal components.
• Ensure proper electrical connections. Connect the red alligator clip to the positive (+) terminal and the black alligator clip to the negative (-) terminal of a 12-volt battery.
• This pump is designed for clean or dirty water. It is not recommended for pumping flammable liquids, corrosive chemicals, or liquids above 120°F (49°C) or below 32°F (0°C).
• Manteña os nenos e o persoal non autorizado lonxe da bomba durante o funcionamento.
• Do not lift the pump by its power cord. Use the portable handle.
• Ensure the pump is placed on a hard, level surface in the water to prevent clogging from mud, sand, silt, or rocky materials.

Contido do paquete

Ao abrir o paquete, comprobe que todos os compoñentes estean presentes e sen danos:

• FLOWPAC FX701-Orange 12V DC Submersible Utility Sump Pump
• 20-foot battery cord with on/off switch
• Battery alligator clips
• 3/4" Garden hose adapter
• Manual de usuario (este documento)

Especificacións do produto

Imaxe: Fronte view of the FLOWPAC FX701-Orange submersible pump, showing its orange body, black discharge port, and attached power cord with alligator clips. A table next to it lists key specifications like voltage, flow rate, and head.

Imaxe: Lateral view of the FLOWPAC FX701-Orange submersible pump, highlighting its thermoplastic pump body, protable handle, intake screen, convenient switch, 20' battery cables, 1-1/4" NPT discharge, 3/4" GHT adapter, and power clips. Dimensions of 9.5" height and 5.7" width are indicated.

Guía de configuración

1. Colocación da bomba

Install the pump on a hard, level surface in the water. If necessary, place bricks or patio blocks under the pump to raise it off the bottom. Do not place the pump directly in mud, sand, silt, or on rocky surfaces as these materials can clog or cause damage to the pump.

2. Conexión da mangueira

Connect a hose to the pump discharge. Use either the supplied garden hose adapter or another hose fitting (sold separately). Choose the best size hose or pipe for your application. NOTA: To keep friction loss as low as possible, do not use a hose that is smaller than 3/4" inner diameter.

Image: An operational guide diagram illustrating pump installation and connection steps. The left side shows pump placement in water, while the right side details electrical connections to a 12-volt battery and the pump's internal operation.

Instrucións de operación

1. Connect the red alligator clip to the positive (+) terminal on your 12-volt battery.
2. Connect the black alligator clip to the negative (-) terminal on your battery.
3. Turn on the pump power switch.
4. The pump will start pumping in approximately 1" of water and will drain down to approximately 1/8"-1/4" of the surface.
5. Non deixe que a bomba funcione en seco. The pump depends on water for cooling and lubrication. Operating the pump without water may cause the motor to overheat or cause damage to internal parts. It may also shorten the lifespan of your pump.
6. Esta bomba está equipada cun orificio antibloqueo de aire. Deste orificio emitirá un chorro de auga cando a bomba estea en funcionamento. Esta é unha característica normal desta bomba. O orificio antibloqueo de aire debe limparse periodicamente para evitar que a bomba se bloquee.
7. This pump is not recommended for pumping liquids over 120°F (49°C). Normal operation is for fluids between 32°F (0°C) and 120°F (49°C).
8. Once done pumping, turn off the power switch.

Image: A hand holding the FLOWPAC FX701-Orange submersible pump partially submerged in water, demonstrating its operation as water is being pumped out.

Image: A diagram illustrating multiple applications for the FLOWPAC FX701-Orange submersible pump, including home use, outdoors (ponds), basements, pools, flat roofs, and camping/RV scenarios.

Mantemento

Un mantemento regular garante a lonxevidade e o rendemento óptimo da súa bomba.

• Limpeza: After each use, especially when pumping dirty water, rinse the pump thoroughly with clean water. Inspect the intake screen for debris and clean it to prevent clogging.
• Anti-Airlock Hole: Periodically check and clean the anti-airlock hole to ensure it is free from obstructions.
• Almacenamento: When not in use, store the pump in a dry, frost-free location. Ensure all water is drained from the pump to prevent freezing damage.
• Inspección de cables: Regularly inspect the power cord and alligator clips for any signs of damage, fraying, or corrosion. Replace if necessary.

Resolución de problemas

Garantía e Atención ao Cliente

Información da garantía

This FLOWPAC pump comes with a garantía dun ano from the date of purchase. Please note that defects due to improper use of the pump are not covered under this warranty. It is prohibited to use the pump with no water, as this will void the warranty.

Atención ao cliente

If you have any questions about the product, require technical assistance, or need to make a warranty claim, please do not hesitate to contact our customer support team. You can typically find contact information on the product packaging or the retailer's website where you purchased the pump.

For more information about FLOWPAC products, visit our official websitio: www.flowpac.com