Introdución
This manual provides essential information for the safe and efficient installation, operation, and maintenance of your Paulmann Nova Recessed LED Spot. Please read these instructions carefully before installation and retain them for future reference.
The Paulmann Nova Recessed LED Spot is designed for use in bathrooms, featuring an IP44 rating for splash water protection and a durable stainless steel construction. It uses a GU10 LED bulb with 6.5W power consumption.
Instrucións de seguridade
- A instalación debe ser realizada por un electricista cualificado de acordo coa normativa local de cableado.
- Ensure the power supply is disconnected before installation, maintenance, or bulb replacement.
- Do not connect the luminaire to a dimmer as this model is not dimmable.
- This product is rated IP44, suitable for bathroom zones 2 and 3. Do not install in zones where direct water jets are present.
- Do not cover the luminaire with insulating material.
- Avoid touching the bulb immediately after use as it may be hot.
Contido do paquete
- 1 x Paulmann Nova Recessed LED Spot fixture
- 1 x GU10 LED Bulb (6.5W)
- Instrucións de instalación (este manual)
Imaxe: Explosión view showing the recessed fixture, GU10 LED bulb, and electrical connector.
Configuración e instalación
- Preparación: Asegúrese de que a subministración eléctrica da zona de instalación estea desconectada no disxuntor principal.
- Corte do teito: Create a circular cutout in the ceiling. Refer to the product specifications for the exact cutout diameter (typically around 68mm-75mm).
- Cableado: Connect the luminaire's wiring to the mains supply. Ensure correct polarity (Live, Neutral, Earth) according to local electrical codes. Use appropriate terminal blocks if necessary.
- Inserir lámpada: Insert the GU10 LED bulb into the lamp holder by aligning the pins and twisting clockwise until secure.
- Accesorio seguro: Push the spring clips on the side of the recessed spot upwards and insert the fixture into the ceiling cutout. The spring clips will hold the fixture securely in place.
- Verificación final: Once installed, restore power and test the luminaire.
Image: The Paulmann Nova Recessed LED Spot, fully assembled and emitting light.
Instrucións de funcionamento
The Paulmann Nova Recessed LED Spot operates by connecting to your standard household electrical circuit. Once installed and wired correctly, it can be switched on and off via a wall switch connected to the circuit.
- Encendido/apagado: Use o interruptor de parede para acender ou apagar a lámpada.
- Non regulable: This specific model (93439) is non regulable. Do not attempt to connect it to a dimmer switch, as this may damage the LED bulb or the fixture.
Mantemento
- Limpeza: Desconecte a alimentación antes de limpar. Limpe o aparello cun pano suave eamp pano. Non use produtos de limpeza ou disolventes abrasivos.
- Substitución da lámpada:
- Ensure power is off and the bulb has cooled down.
- Gently twist the GU10 bulb counter-clockwise to remove it from the lamp titular.
- Insert a new GU10 LED bulb (max 6.5W) by aligning the pins and twisting clockwise until secure.
- Inspección: Comprobe periodicamente a instalación para detectar calquera signo de danos ou conexións soltas. Se atopa algún problema, desconecte a alimentación e consulte cun electricista cualificado.
Resolución de problemas
| Problema | Causa posible | Solución |
|---|---|---|
| A luz non acende. | Sen fonte de alimentación. Bombilla defectuosa. Conexión de cableado solta. | Comprobar o interruptor automático. Substitúe a lámpada. Check wiring (ensure power is off). |
| Luz parpadea. | Bombilla solta. Atenuador incompatible (se se usa). Bombilla defectuosa. | Ensure bulb is securely twisted. This model is not dimmable; remove dimmer. Substitúe a lámpada. |
| O aparello quéntase excesivamente. | Bombilla incorrectatage. Ventilación insuficiente. | Ensure bulb is 6.5W GU10 LED. Ensure fixture is not covered by insulation. |
Especificacións
| Característica | Detalle |
|---|---|
| Número de modelo | 93439 |
| Marca | Paulman |
| Dimensións do produto (L x W x H) | 7.8 x 7.8 x 6 cm |
| Peso | 6 quilogramos |
| Material | Ferro |
| Cor | Brushed Iron |
| Estilo | Moderno |
| Clasificación de protección de entrada (IP). | IP44 |
| Número de lámpadas | 1 |
| Compoñentes incluídos | Bombilla |
| Voltage | 230 voltios |
| Característica especial | Impermeable (IP44) |
| Cor de sombra | Branco Cálido |
| Tipo de fonte de luz | LED |
| Tipo de tapa | GU10 |
| Fluxo luminoso | 460 lm |
| Wattage | 6.5 vatios |
| Equivalente incandescente | 32 vatios |
| Regulable | No (Nicht Dimmbar) |
| Vida Media | 15000 horas |
Image: Energy efficiency label indicating the product's energy class and suitability for various light sources.
Garantía e Soporte
Paulmann products are manufactured to high quality standards. For warranty information and customer support, please refer to the official Paulmann websitio web ou póñase en contacto co seu distribuidor local.
Please note that the availability of spare parts is currently unavailable according to product information. Software updates are also not applicable for this product.
Para obter máis axuda, visite: www.paulmann.com
