Manual do usuario do quentador de auga a gas portátil e ducha exterior Qlima PGWH 1010

1. Introdución

Thank you for choosing the Qlima PGWH 1010 Portable Gas Water Heater and Outdoor Shower. This device is designed to provide instant hot water for various outdoor activities such as camping, washing vehicles, or bathing pets. Its portable and compact design ensures convenience and ease of use. Please read this manual thoroughly before installation and operation to ensure safe and efficient use of the product.

2. Instrucións de seguridade

Your safety is paramount. Always follow these instructions to prevent injury or damage.

2.1 Seguridade xeral

• Lea todas as instrucións antes de facer funcionar o aparello.
• Manteña os nenos e as mascotas lonxe do aparello durante o seu funcionamento.
• Use the appliance only in well-ventilated outdoor areas. Never use indoors or in enclosed spaces.
• Do not modify the appliance or use non-original parts.
• Ensure the appliance is stable and securely hung during use.

2.2 Seguridade dos gases

• Use only the specified gas type (G30-butane / propane / LPG) and recommended gas pressure (28-30-37 mbar).
• Always check for gas leaks using soapy water at all connections before each use. Never use an open flame.
• Ensure gas cylinders are stored upright and away from heat sources.
• Disconnect the gas supply when the appliance is not in use or during maintenance.

2.3 Seguridade na auga

• Ensure adequate water pressure (between 0.2 and 10 bar) for proper operation.
• Do not operate the unit without water flowing through it (dry-run protection is included, but it's best to avoid).
• Drain all water from the unit before storing or in freezing conditions to prevent damage.
• The maximum water temperature can reach 70°C. Exercise caution to avoid scalding.

3. Produto rematadoview

The Qlima PGWH 1010 is a compact and portable water heater designed for outdoor use. It features a durable white casing with integrated controls and connections.

Figura 1: Fronte view of the Qlima PGWH 1010 unit with attached shower head and hose.

3.1 Compoñentes

• Unidade principal: The central heating component.
• Mango integrado: For easy carrying and hanging.
• Shower Head with Hose: For water delivery.
• Entrada de gas: Connection point for the gas supply hose.
• Entrada de auga: Connection point for the cold water supply hose.
• Saída de auga: Connection point for the shower hose.
• Removable Drain Valve: Situado na parte inferior para a evacuación da auga.

3.2 Controles e pantalla

Figure 2: Close-up of the control panel.

• Gas Flow Control Knob (Left): Adjusts the gas supply to the burner, influencing the heat output. Marked with flame icons (Min to Max).
• Water Flow Control Knob (Right): Adjusts the water flow rate through the unit. Marked with water droplet icons (Max to Min).
• Pantalla LED: Mostra a temperatura actual da auga.

4. Configuración

Follow these steps to set up your Qlima PGWH 1010 for first use.

4.1 Colocación

• Hang the unit securely using its integrated handle in a well-ventilated outdoor area. Ensure it is stable and cannot fall.
• Keep the unit away from flammable materials and ensure adequate clearance around it.

4.2 Conexión de gas

• Connect the gas supply hose to the gas inlet on the bottom of the unit. Tighten securely.
• Connect the other end of the gas hose to your gas cylinder (butane/propane/LPG) with the appropriate regulator.
• Before opening the gas cylinder valve, apply soapy water to all gas connections. Open the gas valve slowly and check for bubbles, which indicate a leak. If a leak is detected, close the gas valve immediately and re-tighten connections. Do not proceed until all leaks are resolved.

4.3 Conexión de auga

• Connect a cold water supply hose to the water inlet on the bottom of the unit. Tighten securely.
• Connect the shower hose to the water outlet on the bottom of the unit. Tighten securely.
• Ensure the water supply is capable of providing the required pressure (0.2 to 10 bar).

5. Instrucións de funcionamento

Once the unit is properly set up, follow these steps to operate it.

1. Abrir subministración de gas: Slowly open the valve on your gas cylinder.
2. Suministro de auga aberta: Abra o subministro de auga fría á unidade.
3. Iniciar o fluxo de auga: Press the trigger on the shower head to allow water to flow. The unit will automatically ignite once water flow is detected. The LED display will show the current water temperature.
4. Axustar a temperatura:
   • To increase water temperature, turn the Gas Flow Control Knob (left) towards 'Max' or turn the Water Flow Control Knob (right) towards 'Min' (reducing water flow allows more time for heating).
   • To decrease water temperature, turn the Gas Flow Control Knob (left) towards 'Min' or turn the Water Flow Control Knob (right) towards 'Max' (increasing water flow reduces heating time).
5. Apagado: To turn off the unit, first close the gas supply valve on the gas cylinder, then close the water supply tap. The unit will automatically shut down.

Nota: The unit features automatic shut-off and dry-run protection for safety.

6. Mantemento

Un mantemento regular garante a lonxevidade e o rendemento óptimo do seu quentador de auga.

6.1 Limpeza

• Limpe o exterior da unidade cun suave, damp pano. Non use produtos de limpeza ou disolventes abrasivos.
• Ensure the burner area is free from dust and debris.

6.2 Drenaxe e almacenamento

• Before storing the unit or if there is a risk of freezing temperatures, completely drain all water from the system. Use the removable drain valve located at the bottom of the unit.
• Disconnect all hoses and the gas supply.
• Store the unit in a dry, safe place, protected from extreme temperatures and direct sunlight.

7 Solución de problemas

If you encounter issues with your Qlima PGWH 1010, refer to the following common problems and solutions.

• Sen auga quente:
  • Check if the gas cylinder is open and has sufficient gas.
  • Ensure the water supply is open and providing adequate pressure.
  • Verify that the gas and water connections are secure and free of leaks.
  • Confirm that water is flowing through the shower head when the trigger is pressed.
• Unidade que non se acende:
  • Check gas supply and connections as above.
  • Ensure sufficient water flow to activate the ignition sensor.
  • If the unit has batteries for ignition (not explicitly stated but common), check if they need replacement.
• Water Too Hot or Too Cold:
  • Adjust the Gas Flow Control Knob (left) to increase or decrease heat.
  • Adjust the Water Flow Control Knob (right) to increase or decrease water flow. A slower flow generally results in hotter water.
• Baixa presión da auga:
  • Check your external water supply for adequate pressure.
  • Ensure hoses are not kinked or blocked.

If problems persist after following these steps, please contact Qlima customer support.

8. Especificacións

Technical details for the Qlima PGWH 1010 Portable Gas Water Heater.

9. Garantía e soporte

For warranty information and customer support, please refer to the documentation provided with your purchase or visit the official Qlima websitio. Garda o comprobante de compra para calquera reclamación de garantía.