Introdución
Thank you for choosing the Monitor Audio Bronze 200 Floorstanding Speakers. These speakers are designed to deliver high-fidelity audio performance for both music and home theater systems. This manual provides essential information for setting up, operating, and maintaining your speakers to ensure optimal performance and longevity.
O que hai na caixa
- 2 x Monitor Audio Bronze 200 Floorstanding Speakers
- Outrigger Feet and Spikes (pre-attached or included for user installation)
- Rejillas protectoras
Configuración
1 Colocación
A colocación axeitada dos altofalantes é fundamental para conseguir a mellor calidade de son. Ten en conta as seguintes pautas:
- Configuración estéreo: Place the speakers equidistant from your primary listening position, forming an equilateral triangle.
- Distancia desde Walls: Experiment with placing the speakers away from walls to reduce bass boom and improve soundstage.
- Toe-in: Angle the speakers slightly inward towards the listening position to optimize imaging.
2. Conexión a un Ampmáis vivo
The Bronze 200 speakers feature dual binding posts, allowing for bi-wiring or bi-amping for enhanced performance. Ensure your amplifier meets the recommended power requirements of 40-120W and has a nominal impedance of 8 ohms.
- Apague o seu amplifier antes de realizar calquera conexión.
- Conecte o terminal positivo (+) (vermello) do altofalante ao terminal positivo (+) do seu ampmáis vivo.
- Conecte o terminal negativo (-) (negro) do altofalante ao terminal negativo (-) do seu ampmáis vivo.
- Se se realiza bicableado ou bi-ampndo, consulte o seu amplifier's manual for specific instructions. Ensure the metal links between the binding posts are removed if bi-wiring/bi-amping.
Traseira view of the Monitor Audio Bronze 200 speaker, illustrating the dual binding posts for ampconexión de lifier.
Instrucións de funcionamento
Unha vez conectado, asegúrate de que o teu amplifier is set to the correct input source. Start with a low volume and gradually increase it to your desired listening level. The Bronze 200 speakers are designed for a wide frequency response, providing clear highs and deep bass.
Fronte view of the Monitor Audio Bronze 200 speaker without its protective grille, highlighting the C-CAM midbass drivers and Gold Dome tweeter.
The speakers come with protective grilles. It is recommended to keep them on to protect the drivers from accidental damage, especially in households with children or pets. However, for critical listening, some users prefer to remove them.
Fronte view of the Monitor Audio Bronze 200 speaker with its protective grille installed.
Mantemento
To keep your speakers in optimal condition:
- Limpa o armario cun pano suave e seco. Evita o uso de produtos de limpeza abrasivos ou solventes.
- Do not touch the speaker cones or tweeters directly.
- Keep speakers away from direct sunlight, heat sources, and excessive moisture.
Resolución de problemas
If you experience issues with your speakers, try the following:
- Sen son: Comprobe todas as conexións dos cables entre os altofalantes e o amplificador. Garantir o ampO activador está acendido e configurado na entrada correcta.
- Son distorsionado: Reduce the volume. Check speaker wire connections for any loose strands or short circuits. Ensure your ampO lifier non está sobrecargado.
- Son desigual: Verify that both speakers are connected correctly (positive to positive, negative to negative) and that the balance settings on your amplifier are centered.
Especificacións
| Característica | Detalle |
|---|---|
| Nome do modelo | Bronce 200 |
| Formato do sistema | 2.5 vías |
| Resposta en frecuencia (-6 dB) | 45 – 25,000 Hz (Free field) / 35 – 30,000 Hz (In room) |
| Impedancia nominal | 8 ohmios |
| Recomendado AmpRequisitos de lifier | 40-120 W |
| Complemento da unidade motriz | 2 x 5 1/2" C-CAM midbass driver, 1 x 25 mm C-CAM Gold Dome tweeter with UD Waveguide |
| Dimensións externas (H x W x D) | 909 x 229 x 304 mm (35 13/16 x 9 x 11 15/16") (including Outrigger Feet and Spikes) |
| Peso do elemento | 12.8 quilogramos (28.2 libras) |
| Tipo de montaxe | Piso de pé |
| Material | Durable (high quality metal or plastic) |
| Cor | Black, White, Walnut, Urban Gray |
| Modo de saída de audio | Estéreo, Envolvente |
| Tecnoloxía de conectividade | XLR |
Garantía e Soporte
The Monitor Audio Bronze 200 Floorstanding Speakers come with a limited warranty. Please refer to the warranty card included with your product for specific terms and conditions. For technical support or service inquiries, please visit the official Monitor Audio websitio ou póñase en contacto co seu departamento de atención ao cliente.
