Introdución
This manual provides instructions for the Brita UltraMax Elite Water Dispenser. This BPA-free dispenser features Advanced Carbon Core Technology, designed to reduce 30 contaminants, including lead, cadmium, mercury, asbestos, and benzene, while improving water taste and odor by cutting chlorine. With a 27-cup capacity, it offers a convenient and space-efficient solution for filtered water, fitting easily into most refrigerators. The electronic filter indicator helps monitor filter life for timely replacement.
O que hai na caixa
- Brita UltraMax Water Dispenser
- One Brita Elite Water Filter
Instrucións de configuración
- Desembalar e lavar: Remove all components from the packaging. Hand wash the dispenser, lid, and reservoir with mild soap and water. Rinse thoroughly. Do not wash the filter.
- Preparar o filtro: Before first use, rinse the Brita Elite filter under cold tap water for 15 seconds. This removes any loose carbon dust.
- Insira o filtro: Insert the prepared filter into the reservoir. Press down firmly to ensure a tight seal.
- Fill the Dispenser: Place the lid on the dispenser. Open the filling lid and fill the reservoir with cold tap water. The water will filter into the main dispenser. Discard the first two full pitchers of filtered water, or use them for plants, to prime the filter.
- Indicador de filtro definido: Press and hold the "Status" button on the lid for 2 seconds to activate the electronic filter indicator. Select "Elite Filter" by pressing the button until the blue light illuminates next to "Elite Filter". The indicator will flash green when the filter is good, yellow when it's nearing replacement, and red when it needs to be replaced.

Image: Filling the Brita UltraMax Water Dispenser with tap water.

Image: Close-up of a Brita Elite Water Filter.

Image: Inserting the Brita Elite Water Filter into the dispenser reservoir.

Image: The electronic filter life indicator on the dispenser lid.
Instrucións de funcionamento
Enchendo o Dispensador
To refill the dispenser, simply lift the small hinged lid on top of the main lid. Pour cold tap water directly into the reservoir. The water will pass through the filter and collect in the main dispenser. Avoid overfilling to prevent spills.
Dispensador de auga
To dispense filtered water, place a glass or container under the spigot. Push the lever on the spigot upwards to start the water flow. Release the lever to stop the flow.

Image: Dispensing filtered water from the Brita UltraMax Dispenser.
Vídeo: Rematadoview of the Brita UltraMax Large Water Dispenser, demonstrating filling and dispensing.
Filtrar información
The Brita UltraMax Dispenser is compatible with both Elite and Standard Brita filters. The included Elite filter utilizes Advanced Carbon Core Technology to reduce 30 contaminants, including 99% of lead, and lasts for approximately 120 gallons or 6 months. Standard filters typically last for 40 gallons or 2 months.
Indicador de filtro electrónico
The electronic filter indicator on the lid tracks filter life. It will display a green light when the filter is active, a yellow light when it's nearing replacement, and a red light when it's time to replace the filter. To reset the indicator after replacing the filter, press and hold the "Status" button for 2 seconds until the green light flashes.

Image: Brita filter types comparison, showing Original, Plus, and Elite filters.
Vídeo: Review of Brita Filter, demonstrating filter replacement and indicator use.
Mantemento e Limpeza
Limpeza xeral
The dispenser, lid, and reservoir should be hand washed regularly with mild dish soap and rinsed thoroughly. Do not use abrasive cleaners. The filter should not be washed.
Substitución do filtro
Replace the Brita Elite filter every 120 gallons or approximately every six months, or when the electronic filter indicator signals replacement. To replace, remove the old filter from the reservoir, prepare the new filter as per setup instructions, and insert it firmly. Reset the filter indicator.
Video: Demonstration of filling and filter indicator usage for the Brita water filter.
Resolución de problemas
- Filtración lenta: If water filters slowly, ensure the filter is properly seated in the reservoir. If the filter is old, it may be clogged and require replacement.
- Sabor/olor da auga: If filtered water still has an undesirable taste or odor, ensure the filter was properly primed (first two pitchers discarded) and that it is not past its recommended lifespan. Replace the filter if necessary.
- Filtración: Check that the spigot is securely attached and that the dispenser itself has no cracks. Ensure the lid is properly seated.
Video: User review demonstrating the dispenser's slim design and water flow, which can be helpful for visual troubleshooting of fit and dispensing issues.
Especificacións
| Marca | BRITA |
| Nome do modelo | UltraMax |
| Número de modelo do artigo | OB24/OB06 |
| Dimensións do produto (L x W x H) | 5.19" x 13.94" x 9.67" |
| Capacidade | 27-Cup (13.5 Pounds) |
| Material | Polystyrene (BPA-free) |
| Método de purificación | Carbón Activado |
| Característica especial | Cambiar o indicador de filtro |
| Nivel máximo de TDS de auga admitido | 600 ppm |

Image: Dimensions of the Brita UltraMax Water Dispenser.
Información de seguridade
- Use only cold tap water. Do not use hot water or add anything other than water to the dispenser.
- Mantéñase fóra da luz solar directa.
- The dispenser is made from BPA-free materials.
- Handle with care to avoid cracks or damage, especially around the spigot.
Garantía e Soporte
Para obter información sobre a garantía ou a atención ao cliente, consulte o sitio web oficial do fabricante website or contact their customer service directly. Protection plans are available for purchase separately through retailers.
Visit the official BRITA Store for more information: BRITA Store





